Instruction manual

Octaire Control Panel Operation
61
Octaire Instruction Manual
Vertical Interval Sync (VIS) Config
The system must be configured with the Control Panel before it is capable of switching vertical interval
sync signals. For instructions on connecting VIS cables to enclosure(s), see page 32 in the “Installation
and Setup” chapter. After attaching the cables to the connectors and setting the VIS toggle switches on
the CPU, enable VIS using the following steps.
To enable VIS:
1.
Press the Function Key.
The Function menu appears.
2. Locate Setup Options by scrolling with the Control Dial.
3. Press the Select Key.
The Setup Options submenu appears.
Locate VIS Config by scrolling with the Control Dial.
4. Press the Select Key.
The VIS status displays.
5. Use the Control Dial to change setting to VIS Enabled (if setting is on VIS Disabled).
Press the Select Key to choose VIS Enabled.
If the enabling request is successful, the LCD returns to the Setup Options submenu. If the enabling
request fails, the LCD will display an error message. For information on error codes, see page 64.
6. Press the Function Key to return to the Function menu.