Instruction manual

APWeb – Initial Setup by Network Admin

Octaire Instruction Manual

Executing and Disconnecting Switches

APWeb’s two control points for executing and disconnecting switches on an AMX AutoPatch Routing

System are the crosspoints on the XBar Controller (see below) and the macros on the Execute Macro

page (see page 85).

Executing and Disconnecting Switches on the XBar

The XBar Controller is a graphic interface control panel that executes switches on an AMX AutoPatch

Routing System. The XBar can control specific parts of the system through routing levels, which are

referred to as VMs (virtual matrices). For example, the XBar can switch audio-follow-video signals on

one VM, video on another, and audio on yet another. The VM selected will determine which routing

level is being controlled.

Any APWeb server for a single system can be accessed from up to five PCs at the same time. The XBar

for that system can be operated simultaneously from all of the PCs using the same or different VMs.

Simultaneous XBar users can open the VM Selection Pad and update status as needed. Keep in mind that

executing switches on one VM may affect the routing state on the other VMs.

Note: Multiple independent AMX AutoPatch Routing Systems (each with some type of APWeb

server, e.g., a TCP/IP connector on the CPU, an APWeb expansion board, or a module) can be

controlled from a single PC. Each APWeb server can be assigned a unique IP address and a

custom site name. The individual addresses can then be entered as needed in the browser.

Navigating the XBar Controller

The crosspoint images in the XBar’s crossbar field represent the intersections of the input channels and

the output channels.

Use the following features to navigate the XBar:

 VM title block – click to open the VM Selection Pad to change the routing level (VM)

or update system status

 Input channels (on left) – indicate the numbers of the source channels

 Output channels (on top) – indicate the numbers of the destination channels

 Blue crosspoint – blue indicates that there is no active signal; click to route the signal

(the crosspoint will remain blue if the switch is not completed)

 Red crosspoint – red indicates an actively routed signal; click to disconnect the signal

 Cursor over crosspoint – move over I/O pairs to display channel numbers

VM title block (levels)

Input channels

Output channels

Crossbar field with blue

Cursor shows crosspoint

I/O pair numbers

and red crosspoints

Status bar