Instruction manual

APWeb Expansion Board

Optima SD Instruction Manual

Adding an APWeb Board

If the APWeb board has been pre-installed, go directly to the instructions on page 49 for cabling and

applying power to the enclosure.

If the APWeb board was ordered to upgrade a system, complete the steps below and then see the

instructions on page 49 for cabling and applying power.

ESD Warning: To avoid ESD (Electrostatic Discharge) damage to sensitive components, make sure

you are properly grounded before touching any internal Optima SD materials. Use an ESD

wristband and cord with alligator clip attached to a good ground source.

Note: The APWeb board can be installed in either enclosure and into either of the expansion slots.

To add an APWeb board to an enclosure:

Unplug the power cords on both enclosures in the system.

2. Remove the screws holding the expansion plate.

3. Remove the expansion plate.

4. Insert the APWeb board into the empty expansion slot, aligning the board between the

upper and lower guides inside the slot, pushing until the board is flush with the rear of the

enclosure (FIG. 29).

5. Replace the screws.

6. For cabling instructions, including the power-up sequence, see page 49.

FIG. 29 Insert APWeb board into expansion slot and replace screws

Insert APWeb board