Instruction manual

APWeb Expansion Board
52
Optima SD Instruction Manual
 Enter the diagnostic command ~scrv3i3!
Verify that one of the [type] lines displays the following configuration:
BCS mode RS232 port, 9600 (8/1/N/E/NS)
or
BCS mode RS232 port, 9600 (8/1/N/NE/NS)
If APWeb opens, but the Home page displays a message that says, “There is no VM
configuration information available”:
 Log on APWeb using the default Network Administrator’s user name and password (found in
the APWeb Instruction Manual).
 Click the Configuration link. Verify that Force VM Discovery is turned on.
 If Force VM Discovery is not on, check it on and click the Reboot button.
 If the problem persists, contact technical support (see page 34).
~scrv3i3!
[3:Communication Interfaces] count = 3
[interface 1] detected
[type] BCS mode RS232 port, 9600 (8/1/N/E/NS)
[interface 2] detected
[type] MCF5272 FEC Ethernet Controller
[interface 3] detected
[type] Neuron bridge v1.0.3
Interface configuration