Instruction manual

Upgrading the Firmware
51
AXB-PT10/15/30 PosiTrack Camera Controllers
4. Using the up/down arrow keys, select the device to be programmed.
5. Press ENTER for each device as it is selected
6. Press F4 to program the selected device; a loading message appears.
7. Once the .TSK file has been downloaded, the device AXlink LED will begin to flash
repeatedly for about 6 seconds while the on-board firmware is stored and updated.
After wards, the AXlink LED blinks once (to indicate proper communication) and the unit runs
a self-calibration routine.
8. Press F5 to refresh the screen. Verify that the selected device has the correct firmware version.
If any devices still appear with an old firmware version, repeat steps 3 - 5 until it appears with
the correct version.
9. Press F10 to exit the SOFTROM program.
Firmware can be downloaded to multiple device numbers automatically. If multiple devices are
selected, the bottom half of the loading bar indicates the percentage complete for the selected
devices.