Specifications

Button Labelling
28
Novara ControlPads & KeyPads
6. Carefully pull the bottom circuit board straight up and off the standoffs.
The bottom board has the pushbuttons on the reverse side. Be careful not to damage the buttons when
removing the board.
Note the orientation of the board - it must be oriented in the same direction when replaced.
The top of the is indicated by an UP arrow at the top center of the board.
The bottom is indicated by the AMX logo (FIG. 33).
Replacing Key Caps / Button Labels
Once the lower board has been removed, you have full access to the pushbuttons (with Key Caps installed, as shown in
FIG. 34):
1. Carefully pry the Key Cap off of each pushbutton that you need to re-label.
2. Remove the existing acetate Button Label and Insert the replacement Label in each Key Cap. Be sure to place the
Button Label face-down inside the Key Cap, otherwise the label will be seen in reverse once the Key Cap is
installed.
3. Gently replace the Key Cap on the pushbutton:
FIG. 33 Orientation marks on the circuit boards
FIG. 34 Lower circuit board - pushbuttons
FIG. 35 Placing a Button Label inside a Key Cap
UP arrow indicates the top of the board
AMX logo indicates the bottom of the board
Pushbuttons, with Key Caps installed
Pushbutton on Novara keypad
Key Cap
Acetate Button Label (inside the Key Cap)