Corporation Control System Accessories Operation/Reference Guide

Anterus™ RFID Solution

Anterus RFID Solution

ANT-BDG Product Specifications

ANT-BDG Mounting/Installation

ANT-BDG Tags can be mounted on a variety of items. Where permanent fixing is required VHB double-

sided tape is used (Product number L-TA200); otherwise, the tags may be worn on a necklace or clipped

to clothing.

If you will be fixing personnel photos to the ANT-BDG, use a Badge/Slot Punch capable of a throat

reach of 1/4” (FIG. 7).

ANT-BDG Antenna Orientation

ANT-BDG ID Badge tags are typically worn on a necklace or clipped to clothing, which typically results

in a vertical antenna orientation. There is a horizontal orientation for the ANT-BDG Tags, but it is

typically reserved for installations that use the ANT-BDG Tags as windshield-mounted vehicle tags.

ANT-BDG Specifications

RF Specifications: • Tx Frequency: 433 Mhz

• Field strength: < 1600 µV/m

• Modulation: ASK

• Stability: Saw Stabilized

Electrical Specifications: • Power: Internally powered Lithium Battery (non-replaceable)

• Battery Life span: approximately 5 years.

Note: All of the Anterus RFID tags run on non-replaceable batteries, which

provide approximately five years of normal use. Additional and replacement tags

are available from AMX. Contact your customer service representative for details.

Environmental: • Operational temperature: 32º F to 140º F (0º C to 60º C)

• Storage temperature: -4º F to 158º F (-20º C to 70º C)

• Humidity: 5% to 90% (non condensing)

Enclosure: • ABS (ultrasonically sealed) IP 65

•Black

Dimensions (HWD): 3.38" x 2.12" x .19" (86 mm x 54 mm x 5mm)

Weight: 0.8 oz. (22.68 grams)

Certifications: This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

• This device may not cause harmful interference, and,

• This device must accept any interference received, including interference that

may cause undesired operation.

The following standards applied in accordance with Article 5 of the directive, 1999/

5/EC:

• EN 300 220-1 V1.2.1 (1997-11)

• ETS 300 683 (1997-03)

Any modification of this device without the express consent of the manufacturer

could void the user authority to operate the equipment.

FIG. 7

ANT-BDG - Slot Punch dimensions

Depth =.25” (6.35mm)

Punch-out width = 1.625” (41.27mm)

Punch-out height =

.25” (6.35mm)