Specifications

Wiring and Connections
8
Tango Amplifiers
Wiring Diagram - Expanded Configuration
FIG. 4 illustrates stacking up to three Tango Amplifiers units per zone, to allow up to 12 speaker pairs
(24 channels) in a single zone:
To "stack" Tango amplifiers, connect the To Keypad connector on the first Tango Amplifier to the From
Controller connector on the second Amplifier. To add a third Amp to the configuration, connect the To
Keypad connector on the second Amp to the From Controller connector on the third Amp.
The DAS-MET-6SRC Audio Keypad can be connected serially between the Audio Controller and the first
Amp as shown in FIG. 4.
It can also be connected serially between the first and second Amp, between the second and third Amp, or to
the To Keypad port on Amp #3, but only one Keypad can be connected in one zone.
FIG. 4 Wiring Diagram - Expanded Configuration (showing three DAS-TAMP8-SIG 8-Channel Amps)
Tango Audio Controller
Tango Amplifier
DAS-MET-6SRC
Tango Amplifier
Tango Amplifier
#1
#2
#3
Metreau 6-Source Audio Keypad
Note: Only one Keypad can be installed per zone