Specifications

Tango Amplifiers
2
Tango Amplifiers
Product Specifications
Audio Switching
When no audio is present, the Tango amplifier will go into Standby mode and mute the speakers after about 5
seconds. When audio is sensed at the input, the device will un-mute the speakers and the volume may be
controlled by the keypad or remote. The switch time between muting and un-muting is approximately 200
milliseconds.
Tango Amplifiers - Product Specifications
Models Available: DAS-TAMP4-SIG 4-Channel Amplifier:
• US version (120V) - FG1103-21
• Int’l version (240V) - FG1103-23
DAS-TAMP8-SIG 8-Channel Amplifier:
• US version (120V) - FG1103-22
• Int’l version (240V) - FG1103-24
Dimensions (HWD): • 3 1/16” x 17” x 13 1/2” (7.68cm x 43.18cm x 33.52cm)
•RU: 2
Weight: 25.75 lbs (11.68 kg)
Power: • Average usage: 250 W
• Maximum: 750 W
• High current Torroidal power supply
Stereo Output: • Dual mono amplifier stage design
• 60 W per channel (1 KHz continuous .006%@ 8 Ohms THD+N)
• Each Tango amplifier is capable of providing 480 watts @ 8 Ohms
Configuration: • Modular Design - configurable in single pairs up to 4 stereo pairs (8
channels).
• Stackable (up to 3 Tango Amplifiers)
Control Options: • Metreau Audio Keypads (DAS-MET-6SRC, DAS-MET-NUM)
• C-Series speakers using SWT
Front Panel Components:
Light Bar • Blue light bar indicates power status.
Status LED • Blue LED lights when active
Rear Panel Components:
Power Switch & Receptacle The master power switch will remain in the ON position normally.
Output 1-4: SWT connectors provide direct connection to speakers.
From Controller: SWT input port (connects to an Audio Controller)
To Keypad: SWT output port (connects to Matrix keypad or interface)
This connector can also be used to connect to a another Tango Amplifier, to
allow for expansion (up to three Tango Amplifiers units per zone).
See the Wiring Diagram - Expanded Configuration section on page 8 for
details.
Included Accessories: Power Cord
Other AMX Equipment: DAS-MRMK Mi Series Rack Mount Kit (FG1101-60)