Specifications

ManualsBrandsAMX ManualsComputer equipmentEnova DVX-3155HD

Quick Start Guide

Enova DVX-3150HD/3155HD 10x4 All-In-One Presentation Switcher

Overview

The DVX-3150HD-SP (FG1905-15), DVX-3150HD-T (FG1905-17), DVX-3155HD-SP

(FG1905-16), and DVX-3155HD-T (FG1905-18) are ten input, four output, multi-format

matrix switchers with built-in video scalers, microphone mixer, amplifier, and device

controller. These presentation-style switchers incorporate the following:

• A NetLinx controller (equivalent of a NetLinx 3101-SIG central controller)

• Integrated Multi-format and UTP audio / video switcher

• Video scaler

• Audio processor with mic mixing

• Volume controller and audio amplifier

The following table lists the specifications for the Enova DVX-3150HD/3155HD 10x4

All-in-One Presentation Switchers:

* For more details and helpful cabling information, reference the white paper titled

"Cabling for Success with DXLink" available at www.amx.com or contact your AMX

representative.

** "Common building" is defined as: Where the walls of the structure(s) are physically

connected and the structure(s) share a single ground reference.

FIG. 1

Enova DVX-3150HD-SP 10x4 All-In-One Presentation Switcher (front panel)

Enova DVX-3150HD/3155HD Specifications

Power: 100-240V, 47/63 Hz AC supply

Power

Consumption:

• 90 Watts typical without amplifier

• 95 to 100 Watts typical average with amplifier

• 30 Watts typical in low-power mode

Memory: • 256 MB SDRAM

• 4 GB Flash

• 1 MB Non-volatile (NVRAM)

Amplifier: • 2 x 25W into 8 Ohms Class D stereo amplifier (capable of driving

loads in the range of 2-8 ohms) (-SP devices only)

• 70V or 100V at 75W amplified variable mono audio (-T devices only)

Enclosure: Metal with black matte finish

Integrated

Controller:

Equivalent of a NetLinx 3101-SIG central controller on-board.

Front Panel Components:

LEDs: • LINK/ACT (green) - blinks when receiving Ethernet data packets.

• STATUS (green) - blinks when the system is communicating

properly.

• INPUT (yellow) - blinks when the Controller is receiving data.

• OUTPUT (red) - blinks when the Controller is transmitting data.

• RS-232/422/485 (red/yellow) - indicate ports are transmitting or

receiving data.

• RELAYS (red) - indicate whether relay channels are active (closed).

• IR/SERIAL (red) - indicate whether IR/Serial channels are

transmitting control data.

• I/O (yellow) - indicate whether I/O channels are active.

LCD display: Displays volume level and Video, Audio, and Status menu options.

Front panel

pushbuttons:

• Switch

• Video Menu

•Status

• Video Mute

• Navigational buttons

•Take

• Audio Menu

• Exit

• Audio Mute

Rear Panel Components:

RS-232/422/485 6 DB9 (male) connectors for serial control

RELAYS 1 8-pin 3.5 mm captive-wire connector for Relay control

IR/SERIAL 8 2-pin 3.5 mm captive-wire connectors for IR/Serial control

I/O 1 4-channel binary I/O port for contact closure and voltage sensing.

AUDIO INPUTS: 8 analog audio inputs:

• 4 female 1/8" stereo mini-phono jacks for unbalanced audio

• 4 3.5mm 5-pin captive-wire connectors for line level audio

MIC INPUTS: 2 3.5mm 3-pin captive-wire connectors for up to 2 mono microphones

AMP OUT: • 1 5mm 4-pin captive wire connector (-SP devices only).

• Two 2-position captive wire connectors for 70V or 100V mono

amplified audio output (-T devices only).

AUDIO

OUTPUTS:

3 3.5mm 5-pin captive-wire connectors for line level audio

Enova DVX-3150HD/3155HD Specifications (Cont.)

S/PDIF

OUTPUT:

1 Coaxial RCA connector for digital S/PDIF audio output

MULTI-FORMAT

VIDEO INPUTS:

4 DVI-I input connectors

HDMI INPUTS: • 6 HDMI inputs (5-10) (DVX-3150HD devices only)

• 4 HDMI inputs (5-8) (DVX-3155HD devices only)

DXLINK

INPUTS:

2 RJ-45 inputs (9-10) for video, audio, Ethernet, and bi-directional

control of DXLink devices (DVX-3155HD devices only)

VIDEO

OUTPUTS:

• 4 HDMI Output connectors (1-4)

• 2 DXLink outputs (1, 3) mirror HDMI outputs 1 and 3.

CONFIG DIP

Switch:

8-position Master configuration DIP switch

PROGRAM

Port:

DB9 connector (male) for serial communication.

ID Pushbutton: Black ID pushbutton sets the NetLinx Device ID assignments of the

Internal Control Device.

LAN 10/100

Port:

RJ-45 connector provides TCP/IP communication.

AxLink Port: 1 3.5 mm 4-pin captive-wire connector provides data and power to

external control devices.

Power

Connector:

IEC Power cord connector: 100-240V AC, 47-63Hz

Twisted Pair Cable

Type:

Shielded Cat6, Cat6A, Cat7*

Twisted Pair Cable

Length:

Up to 328 ft. (100 m)*

Important: DXLink twisted pair cable runs for DXLink equipment shall

only be run within a common building.**

Operating

Environment:

Storage temperature: -10º C to 70º C (14º F to 158º F)

Operating Temperature: 0º C to 40º C (32º F to 104º F)

Operating Relative Humidity: 5% to 85% non-condensing

Weight: 18.2 lb (8.26 kg)

Dimensions

(HWD):

5 3/16" x 17" x 14" (13.2 cm x 43.2 cm x 35.6 cm)

Certifications: • FCC Part 15 Class A

• IC CISPR 22 Class A

• LVD EN 60950-1

• cULus UL 60950-1

• C-Tick CISPR 22 Class A

• IEC 60950-1

• CE EN 55022 Class A and EN 55024

Included

Accessories:

• 1 Power Cord, Universal (64-0009)

• 2 Connector, Phoenix2, M, TH, R/A, BLACK, 5.08mm (41-0158-SA)

• 7 Connector, Phoenix5, F, BLACK (41-0336)

• 2 Connector, Phoenix3, F, BLACK (41-0338)

• 1 Connector, Phoenix4, F, TH, BLACK, 3.5mm (41-5047)

• 2 Connector, Phoenix, 8-pin, FEM, BLACK (41-5083)

• 1 Connector, Phoenix, 10-pin, FEM, BLACK (41-5107)

• 2 Front Rack Mounting Brackets (62-1905-16 and 62-1905-17)

• 2 CC-NIRC, IR Emitter with 3.5mm Phoenix Connector

(FG10-000-11)

• 1 CC-DVIM-VGAF, DVI to HD-15 Female Adapter (FG10-2170-13)

• 1 Commoning Strip, Cypher, 8 Pos., 3.5 mm, Phoenix Connector

(41-2105-01)

Optional

Accessories:

• CC-DVI-5BNCM DVI to 5 BNC adapter cable (FG10-2170-08)

• CC-DVI-RCA3M DVI to 3 Male RCA adapter cable (FG10-2170-09)

• CC-DVI-SVID DVI to S-Video adapter cable (FG10-2170-10)

• CC-DVIM-VGAF DVI to HD15 female adapter (FG10-2170-13)

• CC-3.5ST5-RCA2F 5-Pin Phoenix Cable to 2 RCA Female

(FG10-003-20)

• AVB-RX-DXLINK-HDMI DXLink™ HDMI Receiver Module

(FG1010-500)

• AVB-TX-HDMI-DXLINK DXLink HDMI Transmitter Module

(FG1010-300)

• AVB-TX-MULTI-DXLINK DXLink Multi-Format Transmitters

(FG1010-310

)

• AVB-WP-TX-MULTI-DXLINK DXLink Multi-Format Wallplate

Transmitters (FG1010-320-BL/WH)

Summary of content (2 pages)

PAGE 1
Quick Start Guide Enova DVX-3150HD/3155HD 10x4 All-In-One Presentation Switcher Overview Enova DVX-3150HD/3155HD Specifications (Cont.) The DVX-3150HD-SP (FG1905-15), DVX-3150HD-T (FG1905-17), DVX-3155HD-SP (FG1905-16), and DVX-3155HD-T (FG1905-18) are ten input, four output, multi-format matrix switchers with built-in video scalers, microphone mixer, amplifier, and device controller.
PAGE 2
Mounting the DVX into an Equipment Rack The DVX occupies three rack units in a standard equipment rack. Install the included rack mounting brackets using the supplied mounting screws prior to securing the unit in the rack. Warning: The DVX should not be installed in enclosed spaces. ALWAYS ensure that the rack enclosure is adequately ventilated. Do not block any ventilation openings. It is recommended that you leave 1 RU of space above the DVX when you install it in a rack.