User's Manual
Table Of Contents
- ACENDO VIBE™ - INSTRUCTION MANUAL
- Acendo Vibe Conferencing Soundbars
- Installing Acendo Vibe
- Overview
- Credenza Installation
- Wall Mount Installation
- Connections
- Rotating the Acendo Vibe Into the Seated Position
- Installing Lock-Down Screws
- Side Panel Keypad
- Camera (ACV-5100 only)
- Remote Control
- Pairing the Acendo Vibe with a Bluetooth Source Device
- Setting the Acendo Vibe as the Default Audio Device
- Connecting RS232 for Serial Commands
- Connecting an External Motion Sensor (future firmware update / ACV-5100 only)
- Acendo Vibe Configuration Tool
- Configuring Acendo Vibe Conferencing Sound Bars
- Overview
- Downloading and Installing the Acendo Vibe Configuration Tool
- Connecting to the the Acendo Vibe via USB
- Entering Setup Mode
- USB Connected Window
- Transfer Options Window
- Bluetooth Configuration Options
- Events Configuration Options (ACV-5100 only)
- Audio Configuration Options
- File Options (Open, Save and Transfer)
- Serial Commands
- Troubleshooting
Serial Commands
38
Acendo Vibe Conferencing Soundbars - User Guide
Events
Acendo Vibe will send event messages when asynchronous events, i.e. occurrences not related to a received command,
happen.
Note that the Acendo Vibe supports the Command Protocol on both its USB and RS-232 interfaces. However, events are
only reported on the RS-232 interface.
The table below shows the possible events to be reported with the EVENT message:
Event <Event Name> <Event Data>
Event Name Event Data Description
boot_complete
Booting complete
bt_conn
Bluetooth connected
bt_dis
Bluetooth disconnected
bt_remote_conn
Remote control connected
bt_ remote_dis
Remote control disconnected
bt_inactive
Bluetooth audio inactive for 30 minutes
bt_oor
Bluetooth out-of-range for 5 minutes
hdmi_conn
Connection on external HDMI input
hdmi_dis
Disconnection on external HDMI input
mic_mute
Microphone muted
mic_unmute
Microphone unmuted
occupancy_det
Occupancy detected
spkr_mute
Speakers muted
spkr_unmute
Speakers unmuted
src_change_audio
<setting> = “aux”, “bluetooth", “hdmi”, “optical” or “usb” Audio source changed
usb_conn
Connection on external USB
usb_dis
Disconnect on external USB
vacancy_det
No occupancy detected for N seconds
vol_change
<level> = 0..100 Volume changed