User's Manual

Mio R-2 Setup
5
Mio R-2
Mio R-2 Setup
Installing Your Custom Buttons
3. Flip and turn the Mio R-2 device so that the buttons are facing away from you and the device is
upside down.
4. Holding the device in both hands, place your thumbs on the battery door and push up to slide
the battery door free.
5. Unscrew the 6 screw points indicated in FIG. 2.
6. Turn the unit over so the buttons are facing you.
7. Lift the top assembly away from the PCB.
8. If necessary, push out the standard buttons from the front of the top assembly.
9. Drop on your custom button pad and verify the alignment with the guide posts on the PCB.
10. Place the top assembly back down on the PCB and return the unit over, exposing the 6 screw
points.
11. Tighten the 6 screw points.
12. Place the battery door back on the device, slide to lock it in place.
Inserting Batteries into The Mio R-2
To install your 4 AAA batteries into the Mio R-2 device:
1. Flip and turn the Mio R-2 device so that the buttons are facing away from you and the device is
upside down.
2. Holding the device in both hands, place your thumbs on the battery door and slide the battery
door free.
3. Insert the batteries as indicated inside the battery compartment.
4. Place the battery door back on the device, slide to lock it in place.
FIG. 2 Internal Mio R-2 Components
6 Screw Points
Programming Jack