User's Manual

Programming The Mio R-2
7
Mio R-2
Programming The Mio R-2
Most functionality of the Mio R-2 is handled using the application, KeypadBuilder. Go to
www.amx.com for the KeypadBuilder Instruction Manual.
There are a select number of Serial Commands the Mio R-2 recognizes. For a full list and
descriptions, consult the Persistent Serial Commands section on page 11.
Using Connector Ports on The Mio R-2
The programming jack is used for communication between the device and KeypadBuilder. The
programming jack uses a three-wire, 2.5 mm stereo jack, you can order the programming cable
(FG10-817) from AMX if you do not currently possess one. While loading your configuration file
make sure the device is situated as such that the batteries will not fall out. The load will fail if your
batteries fall out during the process.
To download KeypadBuilder Configuration Files:
1. Set the Mio R-2 Download mode to ON. See the Configuration Mode section for details.
2. Flip and turn the Mio R-2 device so that the buttons are facing away from you and the device is
upside down.
3. Holding the device in both hands, place your thumbs on the battery door and slide the battery
door free.
4. Connect the 2.5 mm stereo plug (male) end of the programming cable (FG10-817) into the
programming jack on the bottom side of the remote device.
5. If necessary, connect the DB-9 end of the programming cable to the female DB-9 connector on
the DB-9 extension cable (FG10-727).
6. Connect the female DB-9 terminal end of the extension cable to the port on the back of your
computer.
7. Configure the communication parameters in KeypadBuilder.
FIG. 3 Connecting The Keypad Device to Your PC
Stereo plug male
DB-9 connector
Cable FG10-817 to cable FG10-727
to PC
programming
cable
Keypad device
Programming
jack
Mio R-2