Specifications

Configuring Communication

MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5”

Wireless Communication Using a Static IP Address

From the Protected Setup page, press the Wireless Settings button to open the Wireless Settings page.

Wireless communication is set within the IP Settings section of this page (FIG. 19).

2. Toggle the DHCP/Static field from the IP Settings section until the choice cycles to Static.

The IP Address, Subnet Mask, and Gateway fields then turn red, noting that they are now user-editable.

3. Press the IP Address field to open a keyboard and enter the Static IP Address provided by the System

Administrator. Press Done after entering the IP address information and repeat the same process for the

Subnet Mask and Gateway fields.

4. Press the optional Host Name field to open the keyboard and enter the Host Name information. Press

Done after assigning the alpha-numeric string of the host name.

5. Press the Primary DNS field to open a Keyboard, enter the Primary DNS Address (provided by the

System Administrator) and press Done when compete. Repeat this process for the Secondary DNS field.

6. Press the Domain field to open a Keyboard, enter the resolvable domain Address (this is provided by the

System Administrator and equates to a unique Internet name for the panel), and press Done when

complete.

7. Set up the security and communication parameters between the wireless card and the target AP by

configuring the Wireless Settings section on this page. Refer to the following section for detailed

procedures to set up either a secure or unsecure connection.

Using the Site Survey Tool

This tool allows a user to "sniff out" all transmitting Access Points within the detection range of the internal

wireless card (FIG. 20). Once the Site Survey button is pressed, the device displays the Site Survey page,

which contains the following categories:

Network Name (SSID) - Access Point names

Channel (RF) - Channel currently being used by the AP (Access Point)

Security (if detectable - such as WEP, OPEN and UNKNOWN) - security protocol enabled on the

Signal - displaying the individual APs’ signal level.

MAC Address - Unique identification of the transmitting Access Point

Check with your System Administrator for a pre-reserved Static IP Address to be

assigned to the panel. This address must be obtained before continuing with the

Static assignment of the panel.

FIG. 20 Site Survey page