Corporation NetLinx Integrated Controllers Hardware Reference Guide

Introduction
10
NI-2100, NI-3100, NI-4100 Hardware Reference Guide
NI-4100 Specifications (Cont.)
Rear Panel Components (Cont.):
• Program Port: RS-232 DB9 connector (male) can be connected to a DB9 port on a PC.
This connector can be used with serial and NetLinx programming com-
mands, as well as other DB9 capable devices, to both upload/download
information from the NetLinx Studio program.
• Configuration DIPSwitch: Sets the communication parameters for the Program port (see Baud Rate
Settings).
• ID Pushbutton: Sets the NetLinx ID (Device only) assignment for the device.
• Ethernet Port: RJ-45 connector provides TCP/IP communication. This is an Auto MDI/
MDI-X enabled port, which allows you to use either straight-through or
crossover Ethernet cables.
The Ethernet Port LEDs show communication activity, connection status,
speeds, and mode information:
• SPD (speed) - Yellow LED lights On when the connection speed is 100
Mbps and turns Off when the speed is 10 Mbps.
• L/A (link/activity) - Green LED lights On when the Ethernet cables are
connected and terminated correctly, and blinks when receiving Ethernet
data packets.
• AxLink Port: 4-pin 3.5 mm mini-Phoenix (male) connector that provides data and power
to external control devices. Green AXlink LED indicates the state of the
AXlink port.
• Power Port: 2-pin 3.5 mm mini-Phoenix (male) connector.
• CardFrame #DIP Switch: Sets the starting address for the Control Cards in the CardFrame. (Factory
default CardFrame DIP switch value = 0). The Control Card address range
is 1-3064.
• Control Card Connectors (1-4): 20-pin (male) connectors that connect the Control Cards and
external equipment to the CardFrame.
Included Accessories: • 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
• 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
• 10-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5107)
• Installation Kit (KA2105-01):
- 8-pin Relay Common Strip
- 4 rack mount screws
- 4 washers
• 2 8-pin 3.5 mm mini-Phoenix (female) Relay connectors
(41-5083)
• 2 CC-NIRC NetLinx IR Emitter Cables (FG10-000-11)
• 2 removable rack ears (62-2105-07)
Other AMX Equipment: • 2-pin 3.5 mm mini-Phoenix male connector (41-5026)
• CSB Cable Support Bracket (FG517)
• CC-NSER IR/Serial cables (FG10-007-10)
• NCK, NetLinx Connector Kit (FG2902)
• STS, Serial To Screw Terminal (FG959)
• Upgrade Compact Flash (factory programmed with firmware):
NXA-CF2NI256M - 256 MB compact flash card (FG2116-47)
NXA-CF2NI512M - 512 MB compact flash card (FG2116-48)
NXA-CF2NI1G - 1 GB compact flash card (FG2116-49)