Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
NXA-WAPZD1000 Smart Wireless Access Point
4
NXA-WAP1000 Smart Wireless Access Point
Reset Button
The Hard Reset button (FIG. 2) is used to restart the NXA-WAP1000 or to restore the factory default
configuration. If you hold down the button for less than 10 seconds, the AP will perform a hardware reset. If
you hold down the button for 10 seconds or more, any configuration changes you may have made are removed,
and the factory default configuration is restored to the AP.
Resetting the NXA-WAP1000 to factory default settings will erase all previously
configured settings.