Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Preconfiguring the NXA-WAP1000
12
NXA-WAP1000 Smart Wireless Access Point
4. Click Ye s or OK (depending on the browser) to continue. The AP’s login page appears (FIG. 5).
5. In User Name, type “admin”.
6. In Password, type “1988“.
7. Click Log In. The Browser-Based Configuration page appears, displaying the Device page.
4. Configure the Wireless Settings
To complete this step, you will need to configure the settings on the Common tab and at least one Wireless #
tab. These are the essential wireless settings that will enable wireless devices on the network to associate with
the AP.
FIG. 5 Browser-Based Configuration Pages Login
Default Wireless Settings
SSID (network name): Wireless 1 to Wireless 8 (8 WLANs)
Encryption (security): Disabled on all WLANs
Default management IP address: 192.168.0.1