Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Preconfiguring the NXA-WAP1000
14
NXA-WAP1000 Smart Wireless Access Point
6. Restore the Administrative Computer’s Network Settings
To restore your administrative computer’s original network settings:
1. On your Windows XP or Windows 2000 computer, open the Network Connections (or Network and
Dial-up Connections) control panel according to how the Start menu is set up:
On Windows XP, click Start > Control Panel > Network Connections.
On Windows 2000, click Start > Settings > Network Connections.
2. When the Network Connections window appears, right-click the icon for Local Area Connection, and
then click Properties.
3. When the Local Area Connection Properties dialog box appears, select Internet Protocol (TCP/IP) from
the scrolling list, and then click Properties. The TCP/IP Properties dialog box appears.
4. Restore the computer’s network settings by typing the original IP address settings in the TCP/IP
Properties dialog box.
5. On the TCP/IP Properties dialog box, click OK to close it.
6. Click OK again to close the Local Area Connection Properties dialog box.
You are now ready to connect the AP to your network.