Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
19
NXA-WAP1000 Smart Wireless Access Point
Browser-Based Configuration Pages
Logging into the Configuration Pages
All setup and management of the NXA-WAP1000 is done through its Browser-Based Configuration Pages.If
your wireless network will be managed by an NXA-WAPZD1000 ZoneDirector, you can manage APs through
the ZoneDirector rather than logging into each AP’s Web interface individually.
To log into the Configuration Pages:
1. On your PC, open a Web browser window.
2. In the address or location bar, type the IP address of the AP. Be sure to enter it in the correct format:
https://<ip_address>
3. Press <Enter> to connect.
4. If a Windows security alert dialog box appears, click OK/Yes to proceed. The login page appears
(FIG. 6):
In Username, type admin.
In Password, type 1988.
Click Login.
The following procedure assumes that you know the static IP address of the AP (now
in use), or you have some means of determining the dynamic IP address in use by
the AP, such as checking the router. The PC you use for AP administration should be
on the management VLAN.
FIG. 6 NXA-WAP1000 Login Page