Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
24
NXA-WAP1000 Smart Wireless Access Point
FIG. 11 Status - Radio 2.4G - WLAN page
Radio 2.4G - WLAN
Enable/Disable Auto-update: Click this button to allow or disable the ability for the NXA-WAP1000 to
automatically update its settings and firmware.
Tabs: These tabs access pages for common status settings within a network and
within individual WLANs.
SSID: The name of the accessed network.
BSSID: The broadcast SSID name.
Wireless Status: The current wireless connection status. This may be Up or Down.
Broadcast SSID: This option controls whether or not the WLAN SSID is visible to anyone looking
for wireless networks. Disabling (hiding) the SSID requires that the user be told
the correct SSID before they can connect to your network.
Connected Devices:
MAC Address: The MAC address of the currently connected device.
SSID: The SSID name of the currently connected device.