Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
30
NXA-WAP1000 Smart Wireless Access Point
Configuration - Radio 2.4G - Common Page (Cont.)
Protection Mode: (Inactive by default.) If you activate protection, you control how 802.11 devices
know when they should communicate with another device. This is important in
a mixed environment of both 802.11b and 802.11g clients.
WARNING: Activating this option (and configuring the settings) boosts the
interoperability of 802.11b and 802.11g devices but will severely decrease
performance.
• CTS-only: Choose this option to force all destination devices to acknowledge
their ability to receive data when a transmission is initiated. Use this option
for compliance with the Wi-Fi Alliance certification.
• RTS/CTS: Choose this option to force both sending and receiving devices to
confirm a data exchange on both ends before proceeding.
AeroScout RFID Tag
Detection:
Click the Enable option to enable the AP to relay AeroScout RFID tag data.
AeroScout Engine
communication daemon:
Click the Up option to enable the AP to communicate with your AeroScout
Engine server.
Update Settings: Click this button to save and apply your changes.
Selecting the incorrect country or region may result in violation of applicable laws. If
you purchased the NXA-WAP1000 in the United States, you do not need to manually
set the country code. NXA-WAP1000s that are sold in the US are preconfigured with
the correct country code and this setting cannot be changed.