Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
46
NXA-WAP1000 Smart Wireless Access Point
Upgrading Manually via the Web
To access a particular download Web site:
1. In the Upgrade Method options, click Web. This opens the Web options (FIG. 29).
2. Click the Web Options URL field, and then type the URL of the download Web site. Remember to start
the URL with “http://”.
3. Change the Image Control File filename extension as noted here:
Replace any file names ending in .rcks with the .html extension
Replace any file names ending in .fI7 with the .html extension
4. Click Perform Upgrade. A status bar appears during the upgrade process.
5. After the upgrade is completed, you must manually reboot the NXA-WAP1000.
FIG. 29 Maintenance - Upgrade - Web page
Do not change the Username or Password entries.