Specifications
Table Of Contents
- NXA-WAP1000Smart Wireless Access Point
- NXA-WAPZD1000 Smart Wireless Access Point
- NXA-WAPZD1000 Installation
- Preconfiguring the NXA-WAP1000
- Configuring for Management by NXA-WAPZD1000
- Configuring for Standalone Operation
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the NXA-WAP1000 to the Administrative Computer
- 3. Log Into the AP’s Web Interface
- 4. Configure the Wireless Settings
- Configure Common Wireless Settings
- Configure Wireless # Settings
- 5. Disconnect the AP from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Verify NXA-WAP1000 Operation
- Deploy the Access Point
- Troubleshooting Installation
- Browser-Based Configuration Pages
Browser-Based Configuration Pages
49
NXA-WAP1000 Smart Wireless Access Point
Reboot / Reset
You can use the Browser-Based Configuration Pages to prompt the NXA-WAP1000 to reboot, which simply
restarts the AP without changing any of the current settings. Please note that rebooting the AP will disrupt
network communications in any currently active WLANs.
Rebooting the AP
1.
Go to Maintenance > Reboot/Reset. The Maintenance :: Reboot/Reset page appears (FIG. 32).
2. Click Reboot Now. After a brief pause, you will be automatically logged out of the AP.
After approximately one minute, you should be able to log back into the AP, which verifies that the reboot was
successful. You can also check the LEDs on the AP to verify the status of the device.
Resetting the AP to Factory Defaults
You can use the Web User interface to restore an inoperative AP to its factory default settings, which will
completely erase the configuration currently active in the device. Note, too, that this will disrupt all wireless
network communications through this device.
To reset the AP to factory defaults:
1. Go to Maintenance > Reboot/Reset. The Maintenance :: Reboot/Reset page appears.
2. Click Reset Now (next to Restore to factory settings?).
3. After a brief pause, you will be automatically logged out of the AP. You must now disconnect the AP
from the switch (and the network) and reconnect it to your computer. At this time, you can restore the
network settings, then replace it in your site for full network use.
FIG. 32 Maintenance - Reboot / Reset
Reboot / Reset
Reboot with current
settings?:
Click this button to reboot while saving the currently saved settings.
Reset to factory settings?: Click this link to return the NXA-WAP1000 to its original factory settings.
DO NOT reset the AP to factory defaults unless you are directed to do so by AMX or
Ruckus Wireless support staff or by a network administrator. Do this only if you are
able to immediately reconnect the restored AP to your computer, in order to
reconfigure it for Wi-Fi network use