System information
Table Of Contents
- Table of Contents
- About Integration
- Integrator's Reference
- QS Standalone
- RadioRA 2
- Clear Connect Devices
- Quantum
- HomeWorks QS
- Devices
- GRAFIK Eye QS
- Energi Savr Node QS/DALI
- Energi Savr Node/EcoSystem
- Energi Savr Node QS/Int'l EcoSystem
- Energi Savr Node QS/Int'l 0-10V/Switching
- Energi Savr Node QS/Int'l Phase Adaptive
- Energi Savr Node 0-10V/Switching
- Energi Savr Node QS for International Motor Module
- Remote Power Modules
- Architrave Keypads
- Signature Series Keypads
- seeTouch QS Keypads
- seeTouch QS Int'l Keypads
- Tabletop seeTouch Keypads
- Hybrid Keypad
- Pico Wireless Controls
- Dynamic Keypad
- Wallbox Input Closure Interface
- Sivoia QS Shades
- Sivoia QS Venetian Blinds
- Maestro Dimmers
- Maestro Fan Speed Control
- Visor Control Receiver
- Radio Powr Savr Sensors
- HVAC Controller
- Wireless Temperature Sensor
- Contact Information
119
Lutron® integration protocol
NOTES
1.
2.
Fade is not available for blinds since they move at a constant rate. The parameter must be entered but is ignored.
3. Fractional seconds “SS.ss” will be rounded down to the nearest quarter second. For example, if a delay time
is specified as 1.45 seconds a value of 1.25 seconds will be used.
4. The Delay time is optional. When not used, the system will use a zero second delay. The minimum delay time
is 0.25 seconds. The maximum delay time is 4 hours. Not supported in QS Standalone.
5. The system will report the target lift level and target tilt level of a Venetian blind. The actual levels are not
transmitted while it is moving.
Example: If the Kitchen Venetian (Integration ID 1) is set at 25% lift and 75% tilt, and is commanded to
go to 100% lift and 50% tilt by sending #OUTPUT,1,10,100,50 the response from the system will be
~OUTPUT,1,10,100.00,50.00