Specifications

iv
VG-Series Modero Touch Panels
Table of Contents
Wireless communication using a DHCP Address ........................................................... 93
Wireless communication using a Static IP Address........................................................ 94
Step 2: Configuring the Card’s Wireless Security Settings ..................................... 94
Configuring the Modero’s wireless card for unsecured access to a WAP200G ............. 94
Configuring the Modero’s wireless card for secured access to a WAP200G ................. 96
Configuring multiple wireless Moderos to communicate to a target WAP200G........... 98
Configuring a Wired Ethernet Connection.............................................................. 99
Step 1: Configuring the Panel’s Wired IP Settings.................................................. 99
IP Settings section - Configuring a DHCP Address over Ethernet ................................. 99
IP Settings section - Configuring a Static IP Address over Ethernet.............................. 99
Step 2: Choosing a Master Connection Mode Setting.......................................... 100
Step 3: Configuring the Ethernet Connection Type.............................................. 100
Master Connection - Virtual Master communication over Ethernet............................. 101
Master Connection section - NetLinx Master Ethernet IP Address - URL Mode .......... 103
Master Connection section - NetLinx Master Ethernet IP Address - Listen Mode ....... 104
Master Connection section - NetLinx Master Ethernet IP Address - Auto Mode......... 104
Using G4 Web Control to Interact with a G4 Panel .............................................. 105
Using your NetLinx Master to control the G4 panels............................................ 107
Upgrading Modero Firmware .........................................................................109
Overview .............................................................................................................. 109
Upgrading the Modero Firmware via the USB port .............................................. 109
Step 1: Configure the panel for a USB Connection Type ............................................ 109
Step 2: Prepare NetLinx Studio for communication via the USB port ......................... 110
Step 3: Confirm and Upgrade the firmware via the USB port ..................................... 111
Upgrading the Modero Firmware via an IP Address............................................. 113
Step 1: Prepare the Master for communication via an IP ............................................ 113
Step 2: Prepare the panel for communication via an IP............................................... 114
Step 3: Verify and Upgrade the panel firmware via an IP ........................................... 114
Upgrading Accessory Devices via an IP Address................................................... 116
Step 1: Prepare the NXA-BASE/B for firmware transfer ............................................. 117
Step 2: Upgrade the NXA-BASE/B firmware via an IP................................................. 117
Upgrading the NXA-RGB and NXA-AVB/RGB Firmware....................................... 119
Firmware Pages and Descriptions ..................................................................121
Overview .............................................................................................................. 121
Setup Navigation Buttons..................................................................................... 121
Setup Page ........................................................................................................... 122
Panel Information Page ............................................................................................... 124
Project Information Page............................................................................................. 125
Time & Date Settings Page ......................................................................................... 126