Specifications

Configuring Communication
34
NXD-430/435/435P 4.3” Wall/Flush Mount Touch Panels
Step 3: Configure an Ethernet Connection Type
Before commencing, verify that the NetLinx Master is using the latest available version of its firmware.
Before beginning:
Verify that the panel has been configured to communicate through an Ethernet cable connected
from the panel to a valid Ethernet Hub.
Verify that the NetLinx Master is receiving power and is communicating via an Ethernet connection
with the PC running NetLinx Studio.
Verify that the green Ethernet LED on the rear Ethernet port on the Master is illuminated, indicating
a proper connection.
Verify that the yellow LED on the rear Ethernet port on the Master is blinking, indicating
communication with the device.
1. After the panel powers-up, press and hold the Front Setup Access button for 6 seconds to proceed to the
Status page.
2. Select Protected Setup > System Settings and click the Master tab (FIG. 32).
Master Tab - Virtual Master Communication Over Ethernet
Before beginning, verify that the panel has been configured to communicate through an Ethernet cable
connected from the panel to a valid Ethernet Hub.
1. In NetLinx Studio, select Settings > Master Communication Settings to open the Master
Communication Settings dialog (FIG. 33).
When using Ethernet as the selected communication method, the NetLinx Master
must first be set up with either a Static IP or DHCP Address obtained from either
NetLinx Studio or your System Administrator.
FIG. 32 System Settings Page - Master Tab
Obtained from
NetLinx Master
When configuring the panel to communicate with a Virtual Master (on your PC) via
Ethernet, the Master IP/URL field must be configured to match the IP Address of the
PC. Make sure to use the Virtual System value assigned to the Virtual Master within
NetLinx Studio.