Specifications

Setup Pages and Descriptions

NXD-430/435/435P 4.3” Wall/Flush Mount Touch Panels

Any use of the Reset Settings or Remove Pages buttons opens up the Confirmation Dialog window.

The Ye s button is disabled for 5 seconds while a timer reads down between it and the No button,

and then becomes enabled.

Clicking either button will return you to the Protected Setup page.

Protected Setup Page (Cont.)

Remove Pages: Press this button to remove all current TPD4 touch panel pages currently on the

panel (including the pre-installed AMX Demo pages).

• Pressing this button launches a Confirmation dialog which asks to confirm your

selection.

• This dialog is configured with a delay timer that does not enable the YES button for

5 seconds. This delay provides an additional amount of time for the user to confirm

a decision.

Telnet: Press this button to enable or disable the telnet server on the panel. This feature

focuses on direct telnet communication to the panel.

Function Show: Press this button to enable the display of the channel port and channel code in the

top left corner of the button, the level port and level code in the bottom left corner, and

the address port and address code in the bottom right corner (see FIG. 58 on

page 58).

Page Tracking: Press this button for the touch panel sends page data back to the NetLinx Master, or

vice versa depending on the touch panel settings.

Front Btn Access: Press this button to activate the grey Front Setup Access button (located below the

LCD) to access the firmware pages.

• Default condition is On.

• Press and hold the Front Setup Access button for 6 seconds to access the Setup

page.

• Press and hold the Front Setup Access button for 9 seconds to access the

Calibration page.

Security: Displays one of three security settings: Standard, Secure, and DoD. Pressing this

button opens a popup window allowing changes to the Security Profile. 

NOTE: Refer to the Security Settings section on page 59 for very important 

information on using this feature.

System Settings: Press this button to configure communication settings between the NetLinx Master

and the panel.

Calibrate: Press this button to access the Calibrate Page (page 64).

G4 Web Control: Press this button to enable or disable remote display and control of the panel via a

Web-enabled PC.

Passwords: Press this button to access the Passwords Page (page 67).

Panel Statistics: Press this button to access the Panel Statistics Page (page 68).

Connection Utility: Press this button to access the Connection Utility Page (page 71).

Back: Saves the changes and returns to the previously active touch panel page.