User Guide

NetLinx Modules
71
RMS NetLinx Programmer’s Guide
RMSProjectorMod Module
 Commands
 Strings
 Channels
 Module Definition
Commands
RMSProjectorMod listens for the following commands from the vdvRMSEngine
device.
Commands and Descriptions
'DEV INFO-
[DPS],[Name],[Man],[Model]'
Set device information for device monitoring.
DPS must be in string form (ex: '5001:1:0').
'DEV NAME-[DPS],[Name]'
Set device name for device monitoring. DPS
must be in string form (ex: '5001:1:0').
'COMM TO-[DPS],[Timeout]'
Set the device communication timeout to
Timeout. Timeout is in 1/10-second
increments. Sending a value of zero will
disable the device communication timeout
and the registration of the device
communicating parameter.
'DEV PWR-[DPS],[State]'
Set the device power state. DPS must be in
string form (ex: '5001:1:0'). State must be 1
or 0.
'LAMP HOURS-[DPS],[Value]'
Set the projector lamp hours. DPS must be in
string form (ex: '5001:1:0').
'POWER FAIL ON-[DPS]'
Set power failure detection on. DPS must be
in string form (ex: '5001:1:0').
'POWER FAIL OFF-[DPS]'
Set power failure detection off. DPS must be
in string form (ex: '5001:1:0').
'VERSION'
Send version information to master debug
port (master messaging)