User's Manual
Table Of Contents
- MODERO X® SERIES TOUCH PANELS - INSTALLATION & HARDWARE REFERENCE MANUAL
- Modero X Series (G4) Touch Panels
- MXT/D-2000XL-PAN - 20.3" X Series Panels
- MXT/D-1900L-PAN - 19.4" X Series Panels
- MXT/D-1000 - 10.1" X Series Panels
- MXT/D-700 - 7" X Series Panels
- MXD-430 - 4.3” X Series Panels
- Installing Tabletop (MXT) Panels
- Installing Wall-Mount (MXD) Panels
- A Note About Wall and Rack Installation
- MXD-2000XL-PAN / MXD-1900L-PAN Installation
- MXD-1000/ MXD-700 Installation
- MXD-430 Installation
- Upgrading Firmware
- Troubleshooting
Installing Wall-Mount (MXD) Panels
66
Modero X® Series Touch Panels - Installation & Hardware Reference Manual
2. On the top of the MXD-430, locate the seventh ventilation holes from each edge, on the row closest to the glass (FIG. 60):.
3. With a stout, strong point (a push pin or straightened paper-clip, for example), carefully press straight into the access holes in
the center of the molding (FIG. 60) until the snap is disconnected.
Grasp the top of the panel and pull gently outward until the side of the panel is free of the snap. Use your other hand to
stabilize the front of the touch panel.
NOTE: Always pull on the frame of the touch panel. NEVER pull on the glass edge.
4. With the edge of the touch panel free, carefully lift down and out to remove the touch panel from the Backbox. Be careful not
to pull on the cables or connectors.
5. To reattach the panel to its Backbox repeat the installation procedure.
FIG. 59
MXD-430 Molding (highlighted in blue)
FIG. 60 Top View of the MXD-430 showing access holes in molding
Molding
Access hole Access hole
Panel (surface)
#7
#7