User's Manual

ManualsBrandsAn Energy Technology ManualsElectronicsOnboard 15W Wireless Charging

User Manual

Product Overview

Product Introduction: This product is installed in the dashboard as part of the electric

assisted kickscooter, See the above picture.

When the user is actually using the kickscooter, this product can be used for

swiping the card and charging the mobile phone, and when using time, the user will

not touch the product and should keep a certain distance, at least 20cm.

I.More introduction

This product offers a configurable charging mode that supports 15W.15W power supply

meets WPC QI standard RX.Supports foreign body detection, if there is a foreign body, as a

metal conductive material, between the transmitter and the receiver, the transmitter is off.

Place the mobile phone in the wireless charging tray, charge the mobile phone, and stop

charging after removing the mobile phone. Magnetic card into the NFC induction area when

the card operation!

II. Product parameters

Name: Onboard 15W Wireless Charging

Model: W015CN - 03

Color: black

Input voltage: DC 36V

Input current: 2A(Max)

Operating Temperature: 14–104°F (-10–40°C)

Storage Temperature: -4–122°F (-20–50°C)

III. characteristics

Summary of content (6 pages)

PAGE 1
User Manual Product Overview Product Introduction: This product is installed in the dashboard as part of the electric assisted kickscooter, See the above picture. When the user is actually using the kickscooter, this product can be used for swiping the card and charging the mobile phone, and when using time, the user will not touch the product and should keep a certain distance, at least 20cm. I.More introduction This product offers a configurable charging mode that supports 15W.
PAGE 2
○ Meet the WPC QI standard ○ Support foreign body detection ○ RoHS compliance IV. FUNCTION SPECIFICATIONS Wireless Charging Rated power Frequency band(kHz) Modulation Antenna type 15W 120~130 ASK Coil Antenna NFC Frequency band(MHz) Modulation Antenna type 13.56MHz ASK Coil Antenna The wireless charging input terminal VCC is connected to the 18V direct current.
PAGE 3
Features ➢ Supports ISO/IEC 14443A/M1 reader/writer mode ➢ Supports ISO/IEC 14443B reader/writer mode ➢ ISO/IEC14443A 106kbit/s and higher transfer speed at 212kbit/s and 424kbit/s ➢ Typical operating distance in reader/writer mode for communication to a ISO/IEC 14443A card up to 50mm (depending on the antenna size and tuning) ➢ Supports host interfaces  SPI interface up to 10Mbit/s  I2C interface up to 400kbit/s in Fast Mode , and up to 3.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS WARNING When using this product, basic precautions should always be followed, including the following: • Read all the instructions before using the product. • To reduce the risk of injury, close supervision is necessary when the product is used near children. • DO NOT put fingers or hands into the product. • DO NOT use this product if the flexible power cord or output cable is frayed, has broken insulation, or any other signs of damage.
PAGE 5
— Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules.
PAGE 6
Installation As shown in the figure above, fix the Onboard 15W Wireless Charging on the top of the scooter with screws and connect the corresponding wiring harness. Power on the KickScooter and check the battery level and other display shown on the equipment.