Datasheet

PAGE: 17 OF 20
• Screen Peek
DNAREPO NOITCNUF .XEH EDOC
11100000 E0H Screen Peek
－e
This command is used to transfer 1 byte of displayed data to the data stack; this byte can then be read
from the MPU by data access. The logical combination of text and graphic display data on the LCD
screen can be read by this command.
The status (STA6) should be checked just after the Screen Peek command. If the address determined by
the Set Address Pointer command is not in the graphic area, this commands is ignored and a status flag
(STA6) is set.
Refer to the following flowchart.
T6963C or equ.
driven 240X128 DOTS GRAPHIC MODULES