Datasheet
AD5251/AD5252
Rev. B | Page 9 of 28
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
1
2
3
4
5
6
7
AD0
WP
W1
SDA
A1
B1
V
DD
14
13
12
11
10
9
8
B3
A3
AD1
V
SS
SCL
DGND
W3
03823-0-002
AD5251/
AD5252
TOP VIEW
(Not to Scale)
Figure 2. Pin Configuration
Table 5. Pin Function Descriptions
Pin No. Mnemonic Description
1 V
DD
Positive Power Supply Pin. Connect +2.7 V to +5 V for single supply or ±2.7 V for dual supply, where
V
DD
– V
SS
≤ 5.5 V. V
DD
must be able to source 35 mA for 26 ms when storing data to EEMEM.
2 AD0 I
2
C Device Address 0. AD0 and AD1 allow four AD5251/AD5252 devices to be addressed.
3
WP
Write Protect, Active Low. V
WP
≤ V
DD
+ 0.3 V.
4 W1 Wiper Terminal of RDAC1. V
SS
≤ V
W1
≤ V
DD
.
1
5 B1 B Terminal of RDAC1. V
SS
≤ V
B1
≤ V
DD
.
1
6 A1 A Terminal of RDAC1. V
SS
≤ V
A1
≤ V
DD
.
1
7 SDA
Serial Data Input/Output Pin. Shifts in one bit at a time upon positive clock edges. MSB loaded first.
Open-drain MOSFET requires pull-up resistor.
8 V
SS
Negative Supply. Connect to 0 V for single supply or –2.7 V for dual supply, where V
DD
– V
SS
≤ +5.5 V. If
V
SS
is used in dual supply, V
SS
must be able to sink 35 mA for 26 ms when storing data to EEMEM.
9 SCL
Serial Input Register Clock Pin. Shifts in one bit at a time upon positive clock edges. V
SCL
≤ (V
DD
+ 0.3 V).
Pull-up resistor is recommended for SCL to ensure minimum power.
10 DGND Digital Ground. Connect to system analog ground at a single point.
11 AD1 I
2
C Device Address 1. AD0 and AD1 allow four AD5251/AD5252 devices to be addressed.
12 A3 A Terminal of RDAC3. V
SS
≤ V
A3
≤ V
DD
.
1
13 B3 B Terminal of RDAC3. V
SS
≤ V
B3
≤ V
DD
.
1
14 W3 Wiper Terminal of RDAC3. V
SS
≤ V
W3
≤ V
DD
.
1
1
For quad-channel device software compatibility, the dual potentiometers in the parts are designated as RDAC1 and RDAC3.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.