Datasheet

Evaluation Board User Guide UG-290
Rev. 0 | Page 7 of 28
09910-008
Figure 8. VisualAnalog, Main Window
Setting Up the SPI Controller Software
After the ADC data capture board setup is complete, set up the
SPI controller software using the following procedure:
1. Open the SPI controller software by going to the Start menu
or by double-clicking the SPIController software desktop
icon. If prompted for a configuration file, select the appropriate
one. If not, check the title bar of the window to determine
which configuration is loaded. If necessary, choose Cfg
Open from the File menu and select the appropriate file
based on your part type. Note that the CHIP ID(1) field
should be filled to indicate whether the correct SPI
controller configuration file is loaded (see Figure 9).
09910-009
Figure 9. SPI Controller, CHIP ID(1) Box
2. Click the New DUT button in the SPIController window
(see Figure 10).
09910-010
NEW DUT BUTTON
NEW DUT BUTTON
Figure 10. SPI Controller, New DUT Button
3. Note that other settings can be changed in the Customer
tab of the SPIController window. See the appropriate part
data sheet; the AN-878 Application Note, High Speed ADC SPI
Control Software; and the AN-877 Application Note,
Interfacing to High Speed ADCs via SPI, for additional
information.