Datasheet
Data Sheet AD9558
Rev. B | Page 75 of 104
IRQ MASK (REGISTER 0x020A TO REGISTER 0x020F)
The IRQ mask register bits form a one-to-one correspondence with the bits of the IRQ monitor register (0x0D02 to 0x0D09). When set to
Logic 1, the IRQ mask bits enable the corresponding IRQ monitor bits to indicate an IRQ event. The default for all IRQ mask bits is Logic 0,
which prevents the IRQ monitor from detecting any internal interrupts.
Table 48. IRQ Mask for SYSCLK
Address Bits Bit Name Description
0x020A
[7:6] Reserved Reserved
5
SYSCLK unlocked
Enables IRQ for indicating a SYSCLK PLL state transition from locked to unlocked
4 SYSCLK locked Enables IRQ for indicating a SYSCLK PLL state transition from unlocked to locked
3
APLL unlocked Enables IRQ for indicating an APLL state transition from locked to unlocked
2
APLL locked Enables IRQ for indicating an APLL state transition from unlocked to locked
1
APLL cal complete Enables IRQ for indicating that APLL (LCVCO) calibration has completed
0
APLL cal started Enables IRQ for indicating that APLL (LCVCO) calibration has begun
Table 49. IRQ Mask for Distribution Sync, Watchdog Timer, and EEPROM
Address Bits Bit Name Description
0x020B
[7:5] Reserved Reserved
4
Pin program end Enables IRQ for indicating successful completion of a pin program ROM load
3
Sync distribution Enables IRQ for indicating a distribution sync event
2
Watchdog timer Enables IRQ for indicating expiration of the watchdog timer
1
EEPROM fault Enables IRQ for indicating a fault during an EEPROM load or save operation
0
EEPROM complete
Enables IRQ for indicating successful completion of an EEPROM load or save operation
Table 50. IRQ Mask for the Digital PLL
Address Bits Bit Name Description
0x020C
7 Switching Enables IRQ for indicating that the DPLL is switching to a new reference
6
Closed Enables IRQ for indicating that the DPLL has entered closed-loop operation
5
Freerun Enables IRQ for indicating that the DPLL has entered free run mode
4
Holdover Enables IRQ for indicating that the DPLL has entered holdover mode
3
Frequency unlocked Enables IRQ for indicating that the DPLL lost frequency lock
2
Frequency locked Enables IRQ for indicating that the DPLL has acquired frequency lock
1
Phase unlocked Enables IRQ for indicating that the DPLL lost phase lock
0
Phase locked Enables IRQ for indicating that the DPLL has acquired phase lock
Table 51. IRQ Mask for History Update, Frequency Limit and Phase Slew Limit
Address Bits Bit Name Description
0x020D
[7:5]
Reserved
Reserved
4 History updated Enables IRQ for indicating the occurrence of a tuning word history update
3
Frequency unclamped Enables IRQ for indicating a frequency limit state transition from clamped to unclamped
2
Frequency clamped
Enables IRQ for indicating a state transition of the frequency limiter from unclamped to clamped
1 Phase slew unlimited
Enables IRQ for indicating a state transition of the phase slew limiter from slew limiting to not
slew limiting
0
Phase slew limited
Enables IRQ for indicating a state transition of the phase slew limiter from not slew limiting to
slew limiting