Datasheet
Data Sheet AD9633
Rev. 0 | Page 23 of 40
Differential Input Configurations
There are several ways to drive the AD9633 either actively or
passively. However, optimum performance is achieved by driving
the analog inputs differentially. Using a differential double balun
configuration to drive the AD9633 provides excellent perfor-
mance and a flexible interface to the ADC (see Figure 57) for
baseband applications.
For applications where SNR is a key parameter, differential trans-
former coupling is the recommended input configuration (see
Figure 58), because the noise performance of most amplifiers is
not adequate to achieve the true performance of the AD9633.
Regardless of the configuration, the value of the shunt capacitor,
C, is dependent on the input frequency and may need to be
reduced or removed.
It is not recommended to drive the AD9633 inputs single-ended.
VOLTAGE REFERENCE
A stable and accurate 1.0 V voltage reference is built into the
AD9633. VREF can be configured using either the internal 1.0 V
reference or an externally applied 1.0 V reference voltage. The
various reference modes are summarized in the Internal Reference
Connection section and the External Reference Operation
section. The VREF pin should be externally decoupled to
ground with a low ESR, 1.0 F capacitor in parallel with a low
ESR, 0.1 F ceramic capacitor.
Internal Reference Connection
A comparator within the AD9633 detects the potential at the
SENSE pin and configures the reference into two possible modes,
which are summarized in Table 9. If SENSE is grounded, the
reference amplifier switch is connected to the internal resistor
divider (see Figure 56), setting VREF to 1.0 V.
Table 9. Reference Configuration Summary
Selected
Mode
SENSE Voltage (V)
Resulting
VREF (V)
Resulting
Differential
Span (V p-p)
Fixed
Internal
Reference
AGND to 0.2 1.0 internal 2.0
Fixed
External
Reference
AVDD
1.0 applied
to external
VREF pin
2.0
VREF
SENSE
0.5V
ADC
SELECT
LOGIC
0.1µF1.0µF
VIN–A/VIN–B
VIN+A/VIN+B
ADC
CORE
10073-060
Figure 56. Internal Reference Configuration
ADC
R0.1µF
0.1µF
2V p-p
VCM
C
*C1
*C1
C
R
0.1µF
0.1µF 0.1µF
33
200
33
33
33
VIN+x
VIN–x
10073-059
ET1-1-I3
C
C
5pF
R
*C1 IS OPTIONAL
Figure 57. Differential Double Balun Input Configuration for Baseband Applications
2V p-p
R
R
*C1
*C1 IS OPTIONAL
49.9
0.1F
A
DT1-1WT
1:1 Z RATIO
VIN–x
ADC
VIN+x
*C1
C
VCM
10073-056
33
33
200
0.1µF
5pF
Figure 58. Differential Transformer-Coupled Configuration
for Baseband Applications