Use Instructions
Table Of Contents
- GLOSSARY & ACRONYMS
- PART 1. GENERAL SYSTEM INFORMATION
- 2. INDICATIONS AND CONTRAINDICATIONS FOR USE
- 3. WARNINGS AND PRECAUTIONS
- CAUTION
- 6. BASELINE MEASUREMENT PREPARATION AND DEVICE SETUP
- 8. THE ALIGNMENT TOOL
- PART 3. AT-HOME CPM SYSTEM USE
- PART 4. LIGHTS, SOUNDS, AND TROUBLESHOOTING
- 12. CPM DEVICE LIGHTS AND SOUNDS
- 13. BASE STATION INDICATIONS
- 14. BUTTON PRESSES
- 15. GENERAL TROUBLESHOOTING / FAQS
- 15.1 Physician Q&As
- Q: No data from my patient is appearing on the server, but after getting in touch with the patient, they say that they have been taking measurements consistently with no issue and their device is connected to a plugged- in Base Station.
- Q: No size of the CPM Device fits my patient.
- Q: I initiated a patient mode measurement while trying to put the device into Bluetooth pairing mode and now I can’t pair the CPM Device to the Mobile App.
- Q: How do patients get more adhesives when they run out?
- Q: Can the CPM System be used near other electronic or medical equipment such as telephones, televisions, computers, etc.?
- Q: Is data secure when transmitting from the CPM Device to the Mobile App, the Device to the Base Station, or the Base Station to the Cloud platform?
- 15.2 Patient Q&As
- Q: The CPM Device is not lighting up when plugged into the Base Station to charge.
- Q: Nothing happens when I am trying to start a measurement and/or the button is pressed on the CPM Device.
- Q: The device visually does not stick well to my body or is obviously peeling up.
- Q: I lost the clear protective liners for covering the adhesive.
- Q: I pressed the button accidentally/too early and a measurement started before the device was on my body. How do I get the device to stop beeping?
- Q: The CPM Device continues to beep, indicating there are errors, during a measurement.
- Q: Can I shower with the CPM Device or get it wet?
- Q: Can I travel with the CPM System?
- Q: A piece or part broke off the device, base station, or alignment tool.
- Q: What do I do if I think I am having a medical emergency or decompensation event?
- 15.1 Physician Q&As
- PART 5. CLEANING AND MAINTENANCE
- PART 6. SYSTEM SPECIFICATIONS
- PART 7. SYMBOLS GLOSSARY
48
Version C
Clinician Instructions for Use – Device and Mobile Application
C
PART 5. CLEANING AND MAINTENANCE
OF THE SYSTEM
16.
CLEANING
Cleaning is recommended after every several uses of the CPM Device. Gentle cleansers can be used to clean the
Base Station, Device, and Alignment Tool as follows:
In the clinic
Wipe any exposed surfaces of the CPM Device, Base Station, or
Alignment Tool with isopropyl alcohol or alcohol prep pads to clean
the device and/or remove any dirt, stains, lint, etc.
At home
Wipe any exposed surface of the CPM Device, Base Station, or
Alignment tool with alcohol prep pads, baby wipe, or a water-dampened
cloth to clean the device and/or remove any dirt, stains, lint, etc.
IMPORTANT
Do not use cleansing agents on the adhesive
disposables, as this degrades the adhesive and the
device’s ability to stick to the skin.
Also, to preserve cleanliness of the system:
Always replace the clear liners onto the skin-side adhesive before storage in the Base Station. This prevents
dirt, hair, lint, and dust from sticking onto the adhesive and degrading their adhesion.
•
Always close the lid of the Base Station and the Base Station’s adhesive storage compartment after using the
CPM Device. This provides a second level of defense from dust, hair, lint, and dirt and keeps unused
adhesives clean.
Replace the adhesives as soon as there is visible dust, hair, dirt, or lint on the pads, or at least once per week
and discard them in the trash as soon as they are removed from the CPM Device.
•
Make sure the skin is clean before placing the CPM Device on a patient’s chest.