Datasheet

Data Sheet ADuM1200/ADuM1201
Rev. K | Page 21 of 28
ABSOLUTE MAXIMUM RATINGS
Ambient temperature = 25°C, unless otherwise noted.
Table 13.
Parameter Rating
Storage Temperature (T
ST
) −55°C to +150°C
Ambient Operating Temperature (T
A
)
1
−40°C to +105°C
Ambient Operating Temperature (T
A
)
2
−40°C to +125°C
Supply Voltages (V
DD1
, V
DD2
)
3
−0.5 V to +7.0 V
Input Voltages (V
IA
, V
IB
)
3, 4
−0.5 V to V
DDI
+ 0.5 V
Output Voltages (V
OA
, V
OB
)
3, 4
−0.5 V to V
DDO
+ 0.5 V
Average Output Current per Pin (I
O
)
5
−11 mA to +11 mA
Common-Mode Transients (CM
L
, CM
H
)
6
−100 kV/µs to +100 kV/µs
1
Does not apply to ADuM1200W and ADuM1201W automotive grade
products.
2
Applies to ADuM1200W and ADuM1201W automotive grade products.
3
All voltages are relative to the respective ground.
4
V
DDI
and V
DDO
refer to the supply voltages on the input and output sides of a
given channel, respectively.
5
See Figure 3 for maximum rated current values for various temperatures.
6
Refers to common-mode transients across the insulation barrier.
Common-mode transients exceeding the absolute maximum ratings
can cause latch-up or permanent damage.
Stresses at or above those listed under Absolute Maximum
Ratings may cause permanent damage to the product. This is a
stress rating only; functional operation of the product at these
or any other conditions above those indicated in the operational
section of this specification is not implied. Operation beyond
the maximum operating conditions for extended periods may
affect product reliability.
ESD CAUTION
Table 14. Maximum Continuous Working Voltage
1
Parameter Max Unit Constraint
AC Voltage, Bipolar Waveform 565 V peak 50-year minimum lifetime
AC Voltage, Unipolar Waveform
Functional Insulation 1131 V peak Maximum approved working voltage per IEC 60950-1
Basic Insulation 560 V peak Maximum approved working voltage per IEC 60950-1 and VDE V 0884-10
DC Voltage
Functional Insulation 1131 V peak Maximum approved working voltage per IEC 60950-1
Basic Insulation 560 V peak Maximum approved working voltage per IEC 60950-1 and VDE V 0884-10
1
Refers to continuous voltage magnitude imposed across the isolation barrier. See the Insulation Lifetime section for more details.