Datasheet

ADuM1400/ADuM1401/ADuM1402
Rev. D | Page 14 of 24
ABSOLUTE MAXIMUM RATINGS
Ambient temperature = 25°C, unless otherwise noted.
Table 9.
Parameter Symbol Min Max Unit
Storage Temperature T
ST
−65 +150 °C
Ambient Operating Temperature T
A
−40 +105 °C
Supply Voltages
1
V
DD1
, V
DD2
−0.5 +7.0 V
Input Voltage
1, 2
V
IA
, V
IB
, V
IC
, V
ID
, V
E1
,V
E2
−0.5 V
DDI
+ 0.5 V
Output Voltage
1, 2
V
OA
, V
OB
, V
OC
, V
OD
−0.5 V
DDO
+ 0.5 V
Average Output Current per Pin
3
Side 1 I
O1
−18 +18 mA
Side 2 I
O2
−22 +22 mA
Common-Mode Transients
4
−100 +100 kV/μs
1
All voltages are relative to their respective ground.
2
V
DDI
and V
DDO
refer to the supply voltages on the input and output sides of a given channel, respectively. See the PC Board Layout section.
3
See Figure 4 for maximum rated current values for various temperatures.
4
Refers to common-mode transients across the insulation barrier. Common-mode transients exceeding the Absolute Maximum Ratings may cause latch-up or
permanent damage.
Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only;
functional operation of the device at these or any other conditions above those indicated in the operational section of this specification is
not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
ESD CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily accumulate on
the human body and test equipment and can discharge without detection. Although this product features
proprietary ESD protection circuitry, permanent damage may occur on devices subjected to high energy
electrostatic discharges. Therefore, proper ESD precautions are recommended to avoid performance
degradation or loss of functionality.
Table 10. Truth Table (Positive Logic)
V
IX
Input
1
V
EX
Input
2
V
DDI
State
1
V
DDO
State
1
V
OX
Output
1
Notes
H H or NC Powered Powered H
L H or NC Powered Powered L
X L Powered Powered Z
X H or NC Unpowered Powered H Outputs return to the input state within 1 μs of V
DDI
power restoration.
X L Unpowered Powered Z
X X Powered Unpowered Indeterminate
Outputs return to the input state within 1 μs of V
DDO
power restoration
if V
EX
state is H or NC. Outputs return to high impedance state within
8 ns of V
DDO
power restoration if V
EX
state is L.
1
V
IX
and V
OX
refer to the input and output signals of a given channel (A, B, C, or D). V
EX
refers to the output enable signal on the same side as the V
OX
outputs. V
DDI
and
V
DDO
refer to the supply voltages on the input and output sides of the given channel, respectively.
2
In noisy environments, connecting V
EX
to an external logic high or low is recommended.