Datasheet

ADSP-21262 EZ-KIT Lite Evaluation System Manual 2-19
ADSP-21262 EZ-KIT Lite Hardware Reference
Power Jack (J7)
The power connector (J7) provides all of the power necessary to operate
the EZ-KIT Lite board.
The power connector supplies DC power to the EZ-KIT Lite board.
Table 2-8 shows the power supply specifications.
S/PDIF Coax Connector (J8)
SPI Header (P2)
The SPI connector (P2) provides access to all of the SPI signals in the from
of a .1” spacing header. In addition, the FLAG1 signal can be used as a chip
select. If you are using
FLAG1 as a chip select, disable the push button asso-
ciated with the flag. For more information, see “Push Button Enable
Switch (SW9)” on page 2-12.
Part Description Manufacturer Part Number
2.5 mm power jack (J7)SWITCHCRAFT
DIGI-KEY
RAPC712X
RAPC712X-ND
Mating Power Supply (shipped with EZ-KIT Lite)
7V power supply CUI STACK DMS070214-P6P-SZ
Table 2-8. Power Supply Specifications
Terminal Connection
Center pin +7 VDC@2.14A
Outer ring GND
Part Description Manufacturer Part Number
Coaxial (J8) SWITCHCRAFT PJRAN1X1U01X