Datasheet

ADSP-21262 EZ-KIT Lite Evaluation System Manual I-3
INDEX
LED_CS signal, 2-12
LEDs
diagram of locations, 1-3, 2-14
LED10 (power), 2-15
LED11 (S/PDIF), 1-10, 2-15
LED1-8 (AD0-7/FLAG8-15), 1-12, 2-15
LED9 (processor reset), 2-15
ZLED3 (USB monitor), 1-5, 2-15
license restrictions, 1-7
loop-back test switch (SW11), 2-13
M
master clock (MCLK), 1-9, 1-10, 2-6, 2-11
memory bus (AD15-0), 2-3
microphone
on RCA connector (J4), 1-9
select switch (SW6), 2-9
N
notation conventions, -xxi
O
oscillators, 1-9, 1-10, 2-3, 2-6, 2-10
P
package contents, 1-2
parallel port
block diagram, 2-3
boot mode, 2-3, 2-12
connecting to flash memory, 1-8
pins (AD7-0), 1-12, 2-12, 2-15
power
connector (J7), 2-19
LED (LED10), 2-15
planes, 2-2
specifications, 2-19
supply, 2-19
PPFLG bit, 1-8, 1-12
push buttons
See also switches by name (SWx)
diagram of locations, 2-14
R
R79-80 resistors, 2-3
RCA connectors, 2-18
registration, of this EZ-KIT Lite, 1-3
reset
LED (LED9), 2-15
pin, 2-7
push button (SW5), 2-16
restrictions, of the license, 1-7
S
schematic, of this EZ-KIT Lite, B-1
SCK pin, 2-11
SDATA pin, 2-11
serial peripheral interconnect (SPI)
connections, 2-6
disable switch (SW12), 2-13
flash memory, 1-7
header (P2), 2-19
master boot mode, 2-3, 2-12
setting up AD1835A, 1-9
signal routing unit (SRU), 2-5
S/PDIF
coax connector (J8), 2-19
GPO1 LED (LED11), 2-15
receiver, 1-9
signal enable switch (SW8), 2-11
SPI_CS pin, 2-11
startup, of this EZ-KIT Lite, 1-5
stereo jacks, 2-18
SW10 (boot mode/clock ratio) switch, 2-3, 2-12
SW11 (test) switch, 2-13
SW12 (SPI disable) switch, 2-6, 2-13
SW1 (FLAG1) push button, 2-16
SW2 (FLAG3) push button, 2-16