Datasheet

Connectors
2-26 ADSP-21479 EZ-Board Evaluation System Manual
Headphone Out Connector (J8)
JTAG Connector (P1)
The P1 connector provides access to the JTAG signals of the ADSP-21479
processor. The standalone debug agent requires two connectors, P1 and
ZP1. Pin 3 is missing to provide keying. Pin 3 in the mating connector
must have a plug. For more information, see “JTAG Interface” on
page 1-19.
Remove the standalone debug agent when an emulator is used with the
EZ-Board. Follow the installation instructions provided in “EZ-Board
Installation” on page 1-5, using P1 as the JTAG connection point.
Expansion Interface II Connector (P2)
P2 is a board-to-board connector providing signals for the DAI and DPI
interfaces and GPIO signals of the processor. The connector is located on
the right edge of the board. For more information, see “Expansion Inter-
face II” on page 1-21. For availability and pricing of the connectors,
contact Samtec.
Part Description Manufacturer Part Number
3.5 mm stereo jack CUI SJ1-3525NG
Mating Headphones (shipped with the EZ-Board)
Stereo headphones KOSS 151225 UR5
Part Description Manufacturer Part Number
60-position 0.1”, SMT header SAMTEC TSSH-130-01-L-DV-A
Mating Connector
60-position 0.1”, SMT socket SAMTEC SSW-130-22-F-D-VS