Datasheet

Blackfin A-V EZ-Extender Manual 1-5
A-V EZ-Extender Interfaces
The
P4 connector is designated for a Kodak camera sensor evaluation
module. The interface has been tested with the Kodak KAC-9628 camera
evaluation module. For information about Kodak camera sensors and
evaluation boards, go to
http://www.kodak.com.
To connect the A-V EZ-Extender to a camera module, first determine the
source of the PPI clock. To learn about possible clock settings, refer to
“PPI Clock Setup Jumpers (JP4.1/2, JP4.3/4, JP4.5/6, JP4.7/8)” on
page 2-10. Then set the direction of the data and the frame sync signals,
which depend upon the camera’s configuration. The data must be set as an
input to the PPI port. For more information, refer to “System Architec-
ture” on page 2-2 and “Jumpers” on page 2-7.
Before using these interfaces, follow the steps in “A-V EZ-Extender
Setup” on page 1-1.
Figure 1-1. Camera Orientation