Datasheet

INDEX
I-4 Blackfin A-V EZ-Extender Manual
SCK net, 2-5
serial peripheral interface, See SPI
setup, of this EZ-Extender, 1-1
SNAPSHOT_FODD disconnect jumper, 2-10
SNAPSHOT_FODD_SSEL net, 2-5
SNAPSHOT (Kodak camera) signal, 2-10
SPI
serial clock (SCK), 2-5
serial input data signal (MISO), 2-6
serial output data signal (MOSI), 2-5
SPORT
configuring for I2S mode, 2-13
data connection jumpers, 2-13
data input pins, 2-13
SPORT0
connections, 1-2, 2-2
receive clock signal (RSCLK0), 2-6
receive frame SYNC signal (RFS0), 2-6
transmit clock signal (TSCLK0), 2-6
transmit frame SYNC signal (TFS0), 2-6
system
architecture, of this EZ-Extender, 2-2
reset, 2-14
T
TFS0 net, 2-6
time-division multiplexed (TDM) mode, 1-2
TSCLK0 net, 2-6
two-wire interface (TWI)
signals, 1-4, 2-5
source selection jumpers, 2-7
U
U8 socket, 2-11
unidirectional buffers, 2-2
V
VDEC_CLKOUT net, 2-11
video
decoders, See ADV7183B video decoders
encoders, See ADV7179 video encoders
interface, -x, 1-3, 2-2, 2-4, 2-5
test loopback jumpers, 2-7
VID_IN bus, 2-2, 2-4, 2-10
VID_OUT bus
control jumpers, 2-11
signals, 2-2, 2-4
SYNC enable jumper, 2-13
SYNC source select jumpers, 2-13
voltage selection jumper, 2-7
VS signal, 2-4, 2-5
VSYNC connection jumper, 2-9, 2-10