Datasheet

Evaluation Board User Guide UG-108
Rev. A | Page 3 of 24
QUICK START GUIDE
Follow these steps to quickly evaluate the ADF4002 device:
1. Solder the VCO (T-package compatible).
2. Solder the loop filter components (design with ADIsimPLL™).
3. Connect the reference frequency to J11.
4. Install the system development platform (SDP) drivers.
5. Install the Int-N software.
6. Connect the SDP-S motherboard to the PC and to the EV-ADF4002SD1Z.
7. Follow the hardware driver installation procedure.
8. Connect the power supplies to banana connectors (6 V to 12 V).
9. Run the Int-N software.
10. Select the SDP board and the ADF4002 device in the Select Device and Connection tab of the software front panel window.
11. Click the Main Controls tab. Update all registers.
12. Connect the spectrum analyzer to J2.
13. Measure the results.