Datasheet

UG-161 EV-ADF411XSD1Z User Guide
Rev. A | Page 14 of 28
EVALUATION BOARD SOFTWARE
INT-N PLL SOFTWARE
The control software for the EV-ADF411XSD1Z is provided on
the CD included in the evaluation board kit. To install the
software, see the Installing the Int-N PLL Software section.
To run the software, click the ADI PLL Int-N file on the
desktop or in the Start menu.
On the Select Device and Connection tab, choose the device
and connection method, and then click Connect.
Confirm that SDP board connected is displayed at the bottom
left of the window (see Figure 31). If this message is not displayed,
the software cannot connect to the evaluation board.
Note that when the SDP board is connected, there is about a
5 sec to 10 sec delay before the status label changes.
From the File menu, the current settings can be saved to and
loaded from a text file.
Figure 31. Int-N PLL Software, Main Window—Select Device and Connection
09146-017