Datasheet

UG-161 EV-ADF411XSD1Z User Guide
Rev. A | Page 6 of 28
EVALUATION BOARD SETUP PROCEDURE
INSTALLING THE INT-N PLL SOFTWARE
Use the following steps to install the SDP drivers and the
Analog Devices Int-N PLL software:
1. Install the Int-N PLL software by double-clicking
ADI_Int-N_Setup.msi.
If you are using Windows XP, follow the instructions in the
Windows XP Int-N PLL Software Installation Guide section
(see Figure 3 to Figure 7).
If you are using Windows Vista or Windows 7, follow the
instructions in the Windows Vista and Windows 7 Int-N
PLL Software Installation Guide section (see Figure 8 to
Figure 12).
Note that the Int-N PLL software requires Microsoft Windows
Installer and Microsoft .NET Framework 3.5 (or higher). The
installer connects to the Internet and downloads Microsoft
.NET Framework automatically. Alternatively, before run
ning ADI_Int-N_Setup.msi, both the installer and .NET
Framework can be installed from the CD provided in the
evaluation board kit.
2. Connect the SDP board (black) to a PC using the supplied
USB cable.
If you are using Windows XP, follow the steps in the Windows
XP SDP-S Board Driver Installation Guide section (see
Figure 13 to Figure 16).
If you are using Windows Vista or Windows 7, the drivers
install automatically.
Windows XP Int-N PLL Software Installation Guide
1. Click Next.
Figure 3. Windows XP Int-N PLL Software Installation, Setup Wizard
2. Choose an installation directory, and then click Next.
Figure 4. Windows XP Int-N PLL Software Installation,
Select Installation Folder
3. Click Next.
Figure 5. Windows XP Int-N PLL Software Installation, Confirm Installation
09146-003
09146-004
09146-005