Lite Board Evaluation System Manual

INDEX
I-2 ADSP-21364 EZ-KIT Lite Evaluation System Manual
D
DAI
block diagram, 2-5
connections, 2-10, 2-11
header (P3), 2-19
port
DAI_P17 pins, 2-10
DAI_P19-20 (SW3-4) pins, 1-10, 2-11, 2-15
DAIP6 pins, 2-10
default configuration, of this EZ-KIT Lite, 1-3
digital audio interface, See DAI
digital-to-analog converters (DACs), See
AD1835A
DIP switch SW9, 1-3, 1-10, 2-11
E
electret microphone, 1-9, 2-9
example programs, 1-12
expansion interface, 2-4, 2-6, 2-7, 2-16
external memory, 1-7
F
features, of this EZ-KIT Lite, x
FLAG0 (SPI flash) pins, 1-8, 2-6, 2-7
FLAG1 (SW1/SPI) pins, 1-10, 2-7, 2-11, 2-19
FLAG2 (SW2) pins, 1-10, 2-7, 2-11
FLAG3 (AD1835A select) pins, 1-9, 2-6, 2-7
FLAG registers, 1-10, 2-14
flash memory
boot mode (default), 2-12
start/end addresses, 1-7
via parallel port, 1-7, 2-3
frame sync/clock signals, 1-9, 2-10
frequency, 2-3
G
general-purpose IO pins, 1-10, 1-11, 2-3, 2-6,
2-14, 2-15
H
headphone jack (J6), -xi, 2-17
I
installation, of this EZ-KIT Lite, 1-5
internal boot mode, 2-12
IO
sample rates, 1-8
voltage, 2-2
J
JTAG
connector (ZP4), 2-20
emulation port, 2-8
L
latch-enable pin (ALE), 1-11, 2-3, 2-11
LED_CS signals, 2-11
LEDs
diagram of locations, 1-3, 2-13
LED10 (power), 1-4, 2-14
LED1-8 (general-purpose IO), 1-11, 2-14
LED9 (processor reset), 1-4, 2-14
ZLED3 (USB monitor), 1-5, 2-14
license restrictions, 1-7
loop-back test switch (SW11), 2-13
M
master input clock (MCLK), 1-8, 2-6
memory bus (AD15-0), 2-3
N
notation conventions, -xx
O
oscillators, 1-8, 2-3