user manual

2.4.4 Setting Up the EZ-KIT Lite Hardware
The EZ-KIT Lite evaluation system contains ESD (electrostatic
discharge) sensitive devices. Electrostatic charges readily
accumulate on the human body and equipment and can
discharge without detection. Permanent damage may occur on
devices subjected to high-energy discharges. Proper ESD
precautions are recommended to avoid performance degradation
or loss of functionality. Store unused EZ-KIT Lite boards in the
protective shipping package.
The ADSP-21535 EZ-KIT Lite board is designed to run outside your personal
computer as a stand-alone unit. You do not have to open your computer case.
To connect the EZ-KIT Lite board:
1. Remove the EZ-KIT Lite board from the package. Be careful when
handling the board to avoid the discharge of static electricity, which may
damage some components.
2. Figure 2-1 shows the default jumper settings, DIP Switch, connector
locations, and LEDs used in installation. Confirm that your board is set up
in the default configuration before continuing.
Figure 2-1: EZ-KIT Lite Hardware Setup
ADSP-21535 EZ-KIT Lite Evaluation System Manual
2-4