User manual

P
R
E
L
I
M
I
N
A
R
Y
T
E
C
H
N
I
C
A
L
D
A
T
A
P
R
E
L
I
M
I
N
A
R
Y
T
E
C
H
N
I
C
A
L
D
A
T
A
This information applies to a product under development. Its characteristics and specifications are subject to change with-
out notice. Analog Devices assumes no obligation regarding future manufacturing unless otherwise agreed to in writing.
43REV. PrA
For current information contact Analog Devices at [phone]
ADSP-2192October 2000
TIMING SPECIFICATIONS
I
DD
Supply Current Dynamic
(Internal)
@ 160 MIPS TBD mA
I
DD-IDLE
Supply Current (Idle) V
DDINT
= 2.5V TBD mA
C
IN
Input Capacitance
6, 7
f
IN
=1 MHz,
T
CASE
=25°C,
V
IN
=2.5V
TBD pF
1
Applies to output and bidirectional pins.
2
Applies to input.
3
Applies to input pins with internal pull-ups.
4
Applies to three-statable pins.
5
Applies to three-statable pins with internal pull-ups.
6
Applies to all signal pins.
7
Guaranteed, but not tested.
ABSOLUTE MAXIMUM RATINGS
Parameter Min Max Units
Digital Power Supply, External (V
DDEXT
) –0.3 6.0 V
Analog Power Supply (VCC) –0.3 6.0 V
Input Current (except supply pins) ±10.0 mA
Analog Input Voltage (Signal Pins) –0.3 VCC +0.3 V
Digital Input Voltage (Signal Pins) –0.3 VDD +0.3 V
Ambient Temperature (Operating) 0 +70 °C
Storage Temperature –65 +150 °C
ESD SENSITIVITY
CAUTION: ESD (electrostatic discharge) sensitive device. Electrostatic charges as high
as 4000V readily accumulate on the human body and test equipment and can discharge
without detection. Although the ADSP-2192 features proprietary ESD protection cir-
cuitry, permanent damage may occur on devices subjected to high energy electrostatic
discharges. Therefore, proper ESD precautions are recommended to avoid performance
degradation or loss of functionality.
ELECTRICAL CHARACTERISTICS (CONTINUED)
Parameter Test Conditions Min Max Units