Instruction Manual

Chapter 1 : INTRODUCTION (continued) BROAD SCAN (HD/SDI)
1-9. BROAD SCAN SDI (BSD830) REAR PANEL DESCRIPTION
O / I: AC power switch (O = OFF, I = ON).
POWER: Standard IEC connector (100-250 VAC, 0.5A, 50-60Hz automatic).
RS-232: RS-232 communication port on a DB9 female connector.
IP/LAN: Ethernet communication port on a RJ45 connector (optional).
COMPUTER INPUT & MONITOR
AUDIO IN: Analog stereo audio input on 2x RCA female connector (L = Left, R = Right).
RGB INPUT: Analog computer input on HD15 female connector.
RGB MONITOR OUT: Analog computer output (loop-through) on HD15 female connector.
DVI-D INPUT: Digital computer input on DVI-D female connector.
DVI-D MONITOR OUT: Digital computer output (loop-through) on DVI-D female connector.
ANALOG GENLOCK (Available on BSD830-AG model only).
INPUT: Analog GENLOCK input (Black burst signals).
LOOP OUT: GENLOCK output (loop-through).
DIGITAL GENLOCK (Available on BSD830-DG model only).
INPUT: Digital GENLOCK input (SD-SDI signals).
LOOP OUT: GENLOCK output (loop-through).
VIDEO OUTPUTS
PAL/NTSC: Composite video output (on 1 BNC connector).
LUMA KEY: Luma key video output (on a BNC connector).
FRAME LOCK: Frame lock output (on a BNC connector). This output allows synchronizing external
frame rate such as some graphic card.
S.VIDEO: S.VIDEO output (4-pin mini DIN connector).
R, G, B, S: RGB/S or RGsB video outputs (on 3 or 4 BNC connectors).
Cr, Y, Cb: Component video (SD-YUV) output (on 3 BNC connectors).
SD-SDI
OUT 1 & 2: 2 SD-SDI outputs (on BNC connectors).
LUMA KEY 1 & 2: 2 SD-SDI luma key outputs (on BNC connectors).
PAGE 12